New bare Non-Jet Valve Head

Just like it sounds...The bare head with seats and guides installed with the rocker shaft/cam towers... Ready to have a valve job done and be assembled with your old parts...You will need a head gasket set with stem seals and new head bolts to complete the job.You must replace head bolts everytime you remove the head. If you do not..The bolts will be stretched, not take a torque and you will be doing the job again very quickly...The exception to this is if you install the ARP head studs to replace the bolts...They can be re-used and have 5 times the holding strength of the bolts....